PHOTOGRAPHY BASICS

How to master shutter speed

Your Canon camera's shutter speed is one of the three settings that determine exposure, and also the key to capturing motion. These simple tips will help you master it.
A dirt-bike speeds through a puddle, creating a spray of water while a photographer to one side squats and points a Canon camera at the biker.

Changing your camera's shutter speed is one way to adjust the overall exposure of an image. But it also has creative uses, allowing you to control the amount of motion blur (or lack of it) in your images.

Here are five tips to help you get to grips with shutter speed and take more control over your action photography, whether you're shooting a school sports day with a Canon EOS R100 (which has a shutter speed of up to 1/4000 sec) or wildlife with a Canon EOS R7 (which offers a fast shutter speed of up to 1/16,000 sec).

In a photo taken on a Canon EOS R10 with a shutter speed of 1/2000 sec, a golden retriever is captured running towards the camera.

The Canon EOS R10 offers fast shutter speeds of up to 1/4000 sec (mechanical shutter) or up to 1/16,000 sec (electronic shutter), which is ample for capturing sharp shots of fast-paced action, such as sports or animals in motion. Taken on a Canon EOS R10 with a Canon RF 70-200mm F2.8L IS USM lens at 100mm, 1/2000 sec, f/2.8 and ISO 320.

What is shutter speed?

Shutter speed is the length of time your camera's shutter stays open, and therefore how long the sensor is exposed to light. The longer it's open, the more light hits the sensor and the brighter the image.

Shutter speed is one side of the exposure triangle – the three factors that determine the exposure of an image. The other two are the aperture and the ISO setting. The aperture is how wide or narrow the lens opening is, which also affects how much light reaches the sensor. The ISO setting controls the sensor's sensitivity to light – a higher ISO results in brighter images, but usually at the cost of increased image noise.

A fast shutter speed such as 1/1000 sec, which means the shutter stays open for just a millisecond, can freeze the motion of a fast-moving subject, such as a motorcyclist travelling at speed. A fast shutter speed, however, means less light enters the camera, so you'll normally widen the aperture or raise the ISO to ensure a well-exposed image. A very slow shutter speed such as 1 second would result in the moving motorcyclist being blurred.

The rear screen of a Canon camera showing Shutter Priority (Tv) mode.

To take direct control of the shutter speed, set your camera to Shutter Priority (Tv) or Manual (M) mode.

1. Control the shutter speed

The majority of EOS cameras have a 'Sports' Special Scene Mode that will automatically set up the camera's exposure and focusing settings for shooting moving subjects. This will give you great results, but you can take more control when you want to get creative, produce a particular effect or adjust for the specific circumstances, such as when you're shooting a fast-moving subject handheld from a distance.

To take direct control of the shutter speed, set your camera to Shutter Priority (or Tv, which stands for Time Value). You can then set the shutter speed by rotating the camera's main dial, or by using the touchscreen that's available on many EOS cameras, including the EOS R50 and EOS R8. Your camera will automatically adjust the aperture to produce a standard exposure. If you want to take full control, switch to Manual mode (M) and you can choose any combination of settings you like.

The fastest shutter speed available varies between models, and also according to which shutter mode you select, where a choice is available – mechanical shutter or electronic shutter. The mechanical shutter on a Canon EOS camera typically goes up to either 1/4000 sec or 1/8000 sec, while the electronic shutter in advanced mirrorless EOS R System models can be much faster – up to 1/64,000 sec in the EOS R3. The longest automatically-set shutter speed is 30 seconds. If you want longer exposures, for example for capturing fireworks or light trail photography, you can select Bulb mode. In this mode, the shutter opens when you press the shutter button and stays open until you press it again.

In a photo taken on a Canon EOS R10 with a high shutter speed, a street dancer performs a high kick with one hand on the ground. In the background are four other people and a clump of tall palm trees.

The shutter speed here, 1/3200 sec, was fast enough to freeze movement but there's still a hint of motion blur, for example around the dancer's feet. Thanks to the optical image stabilisation in the lens, however, elements in the scene that are not moving are beautifully sharp. Taken on a Canon EOS R10 with a Canon RF-S 18-45mm F4.5-6.3 IS STM lens at 18mm, 1/3200 sec, f/4.5 and ISO 400.

A sharp zoom image of rowers on the water, captured with a Canon RF-S 18-150mm F3.5-6.3 IS STM lens.

The more you zoom in, the more of a problem camera shake becomes. However, the 4.5-stop optical image stabilisation in the RF-S 18-150mm F3.5-6.3 IS STM lens has effectively minimised this, enabling the photographer to use a shutter speed that isn't particularly high, 1/2000 sec, and still get even the water droplets sharp at a focal length of 100mm. Taken on a Canon EOS R10 with a Canon RF-S 18-150mm F3.5-6.3 IS STM lens at 100mm, 1/2000 sec, f/6.3 and ISO 500.

2. Avoid camera shake

There are two things to think about when you're choosing the shutter speed: whether it is fast enough to avoid blur due to camera movement when you're shooting handheld – also known as "camera shake" – and how quickly the subject is moving.

The shutter speed you need to avoid camera shake depends on a number of things, including how windy it is and whether you are using a lens or camera with built-in image stabilisation. But the focal length of the lens is the most important factor. The more you zoom in, the more noticeable any shake becomes.

A general rule to eliminate this problem is to try to use a shutter speed that's equivalent to the inverse of the effective focal length or faster. So with a 50mm lens setting, use 1/50 sec or faster, and with a 200mm lens use 1/200 sec or faster. Then you need to factor in the speed of the subject – read on.

A blurred shot of a rider on a dirt-bike, the background in focus.

At a shutter speed you'd think is pretty fast, 1/200 sec, this shot creates a great impression of the moving subject speeding past without capturing the detail of the bike or rider. Taken on a Canon EOS 90D with a Canon EF-S 10-18mm f/4.5-5.6 IS STM lens at 11mm, 1/200 sec, f/14 and ISO 1250.

A sharp shot of a rider on a dirt-bike in motion, the background and rider in focus.

At 1/1000 sec, this shot freezes the action. Note also how the aperture has been widened to f/5.6 to preserve correct exposure. Taken on a Canon EOS 90D with a Canon EF-S 10-18mm f/4.5-5.6 IS STM lens at 18mm, 1/1000 sec, f/5.6 and ISO 1250.

3. Capture motion with fast shutter speeds

The shutter speed required to freeze a moving subject depends on the distance it is from the camera, the direction it's moving and its speed, but you'll probably need a shutter speed faster than you might think. A shutter speed of 1/250 sec will freeze a slow-moving subject, such as a person walking, but you'll have to go as high as 1/1000 or even 1/4000 sec for sharp shots of faster subjects such as flying birds and speeding cars. Be prepared to increase the ISO setting to keep the exposure correct when you use faster shutter speeds, especially when you're photographing sports and wildlife.

The downside of freezing the action can be that it doesn't look like action any more. Pictures of moving subjects often look more dynamic if the subject is sharp but the background is blurred. To achieve this effect, make sure the shutter speed is slow enough to give you some blur, then move the camera with the subject, at the same speed as it's moving. This is called panning – learn more in our handy guide to panning.

A photo taken on a Canon EOS R7 of a motorcyclist, sharp against a blurred background because the photographer panned the camera to follow the subject's movement.

Using a relatively slow shutter speed while panning your camera to follow a moving subject produces a sharp subject against a blurred background, making the action look more dynamic. Taken on a Canon EOS R7 with a Canon RF 100-500mm F4.5-7.1 L IS USM lens at 363mm, 1/160 sec, f/10 and ISO 100.

A photo of a skateboarder, sharp against a blurred background because the photographer panned the camera to follow the subject's movement.

Mastering the technique of panning is incredibly useful in all kinds of action photography from sports to wildlife. The trick is to resist the urge to freeze the action. Instead, use a slow enough shutter speed to create motion blur, but follow the moving subject at a matching speed. Taken on a Canon EOS RP (now succeeded by the EOS R8) with a Canon RF 24-105mm F4-7.1 IS STM lens at 26mm, 1/30 sec, f/16 and ISO 100.

4. Shutter speed for video

When you're capturing video, a useful rule of thumb is to set a shutter speed of around 1/2R, where R is the frame rate you're shooting at. For example, if you shoot at 4K 60p on the Canon EOS R10, the ideal shutter speed is about 1/125 sec – just over double the 60fps the camera is shooting at. This avoids blur from too slow a shutter speed, but prevents footage looking choppy, as it would if you used faster shutter speeds.

Water cascading down big mossy rocks. The water is blurred because of the camera's slow shutter speed.

With the camera on a tripod to keep it still, using a long exposure (slow shutter speed) means anything in motion – such as this waterfall – will be blurred, giving water the classic milky look. Taken on a Canon EOS R5 with a Canon RF 14-35mm F4L IS USM lens at 35mm, 1 sec, f/22 and ISO 100.

5. Use slow shutter speeds to blur motion

You can use a relatively long exposure – a slow shutter speed, longer than a second, say – to intentionally blur a picture or blur just the moving elements within an otherwise sharp scene. To prevent this overexposing the shot, though, you'll need to use a narrower aperture setting (higher f-number, such as f/16 or f/22), a lower ISO setting, or an ND filter to limit the amount of light entering the camera. Now you can either move the camera during the exposure (which will blur the whole photo) or use a tripod to keep the camera stationary so that only the moving parts of a scene are blurred. Try the latter technique to soften waves and flowing water in a landscape, or to blur moving vehicles and crowds of people in a city scene.

For exposures longer than 30 seconds, use Bulb mode. Some Canon cameras have a 'B' setting on their mode dial, while others need to be set to 'M' (Manual) before you can scroll through the shutter speeds until 'BULB' is displayed. A remote timer or wired remote can be useful, to eliminate the risk of jarring caused by pressing the shutter button. You could also consider using the Canon Camera Connect app to control your camera remotely from your smartphone.

Understanding shutter speed, and how to control it, will enable you to get the most from your camera and lens, helping you capture great images every time.


Written by Marcus Hawkins and Pete Wolinski

Related Products

Related articles

  • PHOTOGRAPHY BASICS

    How to control exposure

    Master aperture, shutter speed and ISO settings.

  • PHOTOGRAPHY BASICS

    Panning photography for beginners

    Discover how to use panning for better action photos with these top tips.

  • MOTION PHOTOGRAPHY

    Capturing motion in photography

    Discover how to capture motion and add a feeling of movement to your images.

  • ACTION PHOTOGRAPHY

    Best lenses for action

    Our guide to the best lenses for action photography.